Every Pleatco filter uses ADVANCE filter media which has the highest fiber count per unit to maximises filtration offering greater dirt holding capacity leaving your water clean and clear! Combine this filtration with the FREE FLOW COREŽ for low pressure and higher flow rates you can be assured that your pump is working with less wear and tear.
Please note that the threaded spigots used on Pleatco filters are removable and reusable!, They click into position on the filters. Therefore yours might still be in the filter housing of your spa after removing your filter. This is a great feature and great news if you have accidently ordered the incorrect thread pattern.
|Replaces Filters by||Darlly, Filbur, Great Barrier, Unicel|
|Darlly Ref||SC702, 60521|
|Great Barrier Ref||8548|
|Filter Diameter||168 mm|
|Filter Length||378 mm|
|Filter Bottom||Male Thread - SAE Course|
|Spigot Diameter OD||61 mm|
|Filtration Area||60 sq.ft|
|Note||Jacuzzi Spas 6540-476, Jacuzzi Spas 6541-383, Jacuzzi Premium J-300 series & 6540-164 J-LX/J-LXL Series since 2011 J-495, J-425, J415.|
Pleatco Filters are designed to keep your hot tub water crystal clear for up to twelve months when used in conjunction with a proper maintenance regime.
Our recommendation is as follows:
For best results Pleatco recommend using two cartridges in rotation, with one in service in the hot tub and one on standby. This will allow you to leave the out of service filter soaking in detergent for 24 to 48 hours, thoroughly removing any residues from it, and give it ample time to dry out fully before being refitted. Allowing the filter to fully dry will improve its performance upon being refitted.
In many cases a filter which is 5 to 10mm bigger, either in height or diameter will fit into the receiver of your hot tub, and many people choose to do this, either because their own filter is difficult to source or has gone out of production, or because it offers a significant cost saving.
The first consideration is usually the 'top' of the cartridge. If your filter cartridge has a closed top, then you cannot use a cartridge with a hole in it, as water will simply go down the hole and bypass the cartridge. If the top is identical looking and the bottom thread is also identical, then providing the square footage of the cartridge is within ten to fifteen percent of your original (and it fits in your spa) then it is unlikely to have any detrimental affect.
Warning: It is possible to starve pumps of water or cause them to work unnecessarily hard by using filters which are significantly out of specification and this may cause damage to your hot tub.
There are currently no questions for this product.